Deutsch
EnglishThings to remember when driving for your BMW X4 2014-2018
Driving tips
Things to remember when driving
Things to remember when driving
Avoid full load or kickdown under all circum‐
stances.
Vehicle features and options
This chapter describes all standard, country-
specific and optional features offered with the
series. It also describes features that are not
necessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and
systems, the applicable country provisions
must be observed.
From 1,200 miles/2,000 km
The engine and vehicle speed can gradually be
increased.
Tires
Tire traction is not optimal due to manufactur‐
ing circumstances when tires are brand-new;
they achieve their full traction potential after a
break-in time.
Drive conservatively for the first
200 miles/300 km.
Breaking-in period
General information
Moving parts need time to adjust to one an‐
other (break-in time).
Brake system
Brakes require an initial break-in period of ap‐
prox. 300 miles/500 km to achieve optimal per‐
formance between brake discs and brake
pads. Drive moderately during this break-in pe‐
riod.
The following instructions will help you to ach‐
ieve a long vehicle life and good efficiency.
During break-in, do not use the Launch Con‐
trol.
Following part replacement
Safety information
The same break-in procedures should be ob‐
served if any of the components above-men‐
tioned have to be renewed in the course of the
vehicle's operating life.
WARNING
Due to new parts and components,
safety and driver assistance systems can react
with a delay. There is a risk of an accident. Af‐
ter installing new parts or with a new vehicle,
drive conservatively and intervene early if nec‐
essary. Observe the break-in procedures of
the respective parts and components.◀
Driving on poor roads
The vehicle combines all-wheel drive with the
advantages of a normal automobile.
NOTE
Engine, transmission, and axle drive
Up to 1,200 miles/2,000 km
Do not exceed the maximum engine and road
speed:
Objects in unpaved areas, e.g., stones or
branches, can damage the vehicle. There is a
risk of property damage. Do not drive on un‐
paved terrain.◀
▷
For gasoline engine 4,500 rpm and
100 mph/160 km/h.
For your own safety, for the safety of passen‐
gers and of the vehicle, heed the following
points:
180
Things to remember when driving
Driving tips
▷
▷
Become familiar with the vehicle before
starting a trip; do not take risks while driv‐
ing.
risk of property damage. Do not drive with the
tailgate open.◀
If driving with the tailgate open cannot be
avoided:
Adjust the speed to the road surface con‐
ditions. The steeper and more uneven the
road surface, the slower the speed should
be.
▷
▷
▷
Close all windows and the glass sunroof.
Greatly increase the air flow from the vents.
Drive moderately.
▷
When driving on steep uphill or downhill
grades: add engine oil and coolant up to
near the MAX mark. Uphill and downhill
grades can be traveled up to no more than
50 %.
Hot exhaust system
WARNING
During driving operation, high tempera‐
tures can occur underneath the vehicle body,
e.g., caused by the exhaust gas system. If
combustible materials, such as leaves or grass,
come in contact with hot parts of the exhaust
gas system, these materials can ignite. There
is a risk of injury or risk of property damage. Do
not remove the heat shields installed and never
apply undercoating to them. Make sure that no
combustible materials can come in contact
with hot vehicle parts in driving operation, idle
or during parking. Do not touch the hot ex‐
haust system.◀
▷
▷
On steep downhill grades, use Hill Descent
Control HDC.
Starting out is possible on uphill grades up
to 30 %. The permissible side tilt is 30 %.
Avoid that the chassis bottom coming in
contact with the ground.
The ground clearance is no more than
7.8 inches/20 cm and can vary according
to the vehicle's load.
▷
When wheels continue to spin, depress the
accelerator so that driving stability control
systems can distribute the driving force to
the wheels. Activate DTC Dynamic Trac‐
tion Control if available.
Mobile communication devices in the
vehicle
WARNING
After a trip on poor roads
Vehicle electronics and mobile phones
can influence one another. There is radiation
due to the transmission operations of mobile
phones. There is a risk of injury or risk of prop‐
erty damage. If possible, in the vehicle's inte‐
rior use only mobile phones with direct con‐
nections to an exterior antenna in order to
exclude mutual interference and deflect the ra‐
diation from the vehicle's interior.◀
After a trip on poor roads, check wheels and
tires for damage to maintain driving safety.
Clear heavy soiling from the body.
General driving notes
Closing the tailgate
WARNING
An open tailgate protrudes from the vehi‐
cle and can endanger occupants and other
traffic participants or damage the vehicle in the
event of an accident, braking or evasive ma‐
neuvers. In addition, exhaust fumes may enter
the vehicle interior. There is a risk of injury or
Hydroplaning
On wet or slushy roads, a wedge of water can
form between the tires and road surface.
This phenomenon is referred to as hydroplan‐
ing. It is characterized by a partial or complete
181
Driving tips
Things to remember when driving
loss of contact between the tires and the road
surface, ultimately undermining your ability to
steer and brake the vehicle.
Objects in the movement area around
pedals and floor area
WARNING
Objects in the driver's floor area can limit
the pedal distance or block a depressed pedal.
There is a risk of an accident. Stow objects in
the vehicle such that they are secured and
cannot enter into the driver's floor area. Use
floor mats that are suitable for the vehicle and
can be safely attached to the floor. Do not use
loose floor mats and do not layer several floor
mats. Make sure that there is sufficient clear‐
ance for the pedals. Ensure that the floor mats
are securely fastened again after they were re‐
moved, e.g., for cleaning.◀
Driving through water
NOTE
When driving too quickly through too
deep water, water can enter into the engine
compartment, the electrical system or the
transmission. There is a risk of property dam‐
age. When driving through water, do not ex‐
ceed the maximum indicated water level and
the maximum speed for driving through wa‐
ter.◀
When driving through water, observe the fol‐
lowing:
Driving in wet conditions
When roads are wet, salted, or in heavy rain,
gently press the brake pedal every few miles.
▷
▷
Drive through calm water only.
Drive through water only if it is not deeper
than maximum 19.6 inches/50 cm.
Ensure that this action does not endanger
other traffic.
▷
Drive through water no faster than walking
speed, up to 3 mph/5 km/h.
The heat generated during braking dries brake
discs and brake pads and protects them
against corrosion.
Braking safely
Your vehicle is equipped with ABS as a stand‐
ard feature.
In this way braking efficiency will be available
when you need it.
Perform an emergency stop in situations that
require such.
Hills
Steering is still responsive. You can still avoid
any obstacles with a minimum of steering ef‐
fort.
WARNING
Light but consistent brake pressure can
lead to high temperatures, brakes wearing out
and possibly even brake failure. There is a risk
of an accident. Avoid placing excessive stress
on the brake system.◀
Pulsation of the brake pedal and sounds from
the hydraulic circuits indicate that ABS is in its
active mode.
In certain braking situations, the perforated
brake discs can emit functional noises. How‐
ever, this has no effect on the performance and
operational reliability of the brake.
WARNING
In idle state or with the engine switched
off, safety-relevant functions, e.g., engine
braking effect, braking force boost and steer‐
ing assistance, are restricted or not available at
all. There is a risk of an accident. Do not drive
in idle state or with the engine switched off.◀
182
Things to remember when driving
Driving tips
Drive long or steep downhill gradients in the
gear that requires least braking effort. Other‐
wise, the brakes may overheat and reduce
brake efficiency.
You can increase the engine's braking effect
by shifting down, going all the way to first gear,
if needed.
Brake disc corrosion
Corrosion on the brake discs and contamina‐
tion on the brake pads are increased by the fol‐
lowing circumstances:
▷
▷
Low mileage.
Extended periods when the vehicle is not
used at all.
▷
▷
Infrequent use of the brakes.
Aggressive, acidic, or alkaline cleaning
agents.
Corrosion buildup on the brake discs will cause
a pulsating effect on the brakes in their re‐
sponse - generally this cannot be corrected.
Condensation water under the parked
vehicle
When using the automatic climate control,
condensation water develops and collects un‐
derneath the vehicle.
Driving on racetracks
Higher mechanical and thermal loads during
racetrack operation lead to increased wear.
This wear is not covered by the warranty. The
vehicle is not designed for motorsports com‐
petitive use.
183
