Care -> Vehicle washes for your BMW X4 2014-2018

Mobility  
Care  
Care  
Minimum distance from glass sunroof:  
31.5 in/80 cm.  
Vehicle features and options  
This chapter describes all standard, country-  
specific and optional features offered with the  
series. It also describes features that are not  
necessarily available in your vehicle, e. g., due  
to the selected options or country versions.  
This also applies to safety-related functions  
and systems. When using these functions and  
systems, the applicable country provisions  
must be observed.  
Automatic vehicle washes  
Safety information  
NOTE  
Improper use of automatic vehicle  
washes can cause damage to the vehicle.  
There is a risk of property damage. Information  
the following instructions:  
Give preference to cloth vehicle washes or  
those that use soft brushes in order to  
avoid paint damage.  
Vehicle washes  
General information  
Avoid vehicle washes with guide rails  
higher than 4 in/10 cm to avoid damage to  
the chassis.  
Regularly remove foreign objects such as  
leaves in the area below the windshield when  
the hood is raised.  
Observe the tire width of the guide rail to  
avoid damage to tires and rims.  
Wash your vehicle frequently, particularly in  
winter. Intense soiling and road salt can dam‐  
age the vehicle.  
Fold in exterior mirrors to avoid damage to  
the exterior mirrors.  
Deactivate rain sensor, if necessary, to  
avoid damage to the wiper system.◀  
Steam blaster and high-pressure  
washer  
If necessary, switch off automatic PDC activa‐  
tion on obstacle detection, e.g., in vehicle  
washes, to reduce PDC false alarms.  
Safety information  
NOTE  
When cleaning with high-pressure wash‐  
ers, components can be damaged due to the  
pressure or temperatures being too high.  
There is a risk of property damage. Maintain  
sufficient distance and do not spray too long  
continuously. Follow the operating instructions  
for the high-pressure washer.◀  
Before driving into a vehicle wash  
In order to ensure that the vehicle can roll in a  
vehicle wash, take the following steps:  
Steptronic transmission:  
1. Drive into the vehicle wash.  
2. Engage selector lever position N.  
3. Deactivate Automatic Hold, refer to  
page 72.  
Distances and temperature  
Maximum temperature: 140 ℉/60 ℃.  
4. Release the parking brake.  
5. Switch the engine off.  
Minimum distance from sensors, cameras,  
seals: 12 inches/30 cm.  
242  
Care  
Mobility  
In this way, the ignition remains switched  
on, and a Check-Control message is dis‐  
played.  
After washing the vehicle  
After washing the vehicle, apply the brakes  
briefly to dry them; otherwise, braking action  
can be reduced. The heat generated during  
braking dries brake discs and brake pads and  
protects them against corrosion.  
NOTE  
Selector lever position P is automati‐  
cally engaged when the ignition is  
switched off. There is a risk of property  
damage. Do not switch drive-ready state  
off in vehicle washes.◀  
Completely remove all residues on the win‐  
dows, to minimize loss of visibility due to  
smearing and to reduce wiper noises and  
wiper blade wear.  
Some vehicle washes do not permit persons in  
the vehicle. The vehicle cannot be locked from  
the outside when in selector lever position N. A  
signal sounds when an attempt is made to lock  
the vehicle.  
Vehicle care  
Vehicle care products  
Exiting a vehicle wash  
To start the engine with Steptronic transmis‐  
sion:  
General information  
BMW recommends using vehicle care and  
cleaning products from BMW.  
1. Make sure that the vehicle key is in the ve‐  
hicle.  
Safety information  
2. Depress the brake pedal.  
WARNING  
3. Press the Start/Stop button.  
Cleansers can contain substances that  
are dangerous and harmful to your health.  
There is a risk of injury. When cleaning the in‐  
terior, open the doors or windows. Only use  
products intended for cleaning vehicles. Fol‐  
low the instructions on the container.◀  
Pressing the Start/Stop button without step‐  
ping on the brake turns the ignition off.  
Selector lever position  
Selector lever position P is engaged automati‐  
cally:  
Vehicle paint  
When the ignition is switched off.  
After approx. 15 minutes.  
Regular care contributes to driving safety and  
value retention. Environmental influences in  
areas with elevated air pollution or natural con‐  
taminants, such as tree resin or pollen can af‐  
fect the vehicle's paintwork. Tailor the fre‐  
quency and extent of your vehicle care to  
these influences.  
Headlamps  
Do not rub dry and do not use abrasive or  
acidic cleansers.  
Soak areas that have been dirtied, e.g.,  
from insects, with shampoo and wash off  
with water.  
Aggressive substances such as spilled fuel, oil,  
grease or bird droppings, must be removed im‐  
mediately to prevent the finish from being al‐  
tered or discolored.  
Thaw ice with de-icing spray; do not use an  
ice scraper.  
243