Deutsch
EnglishIn the event of a breakdown -> Tool kit for your Peugeot 2008 2019-2025
In the event of a breakdown
For more information on Refuelling and
on Misfuel prevention (Diesel), refer to
the corresponding section.
Assembling and placing the
triangle
Warning triangle
This reflective and dismantlable device is to be
installed on the side of the road when a vehicle
is broken down or damaged.
8
1.5 BlueHDi engines
Before getting out of the vehicle
Turn on the hazard warning lamps, then
put on the safety vest to assemble and install
the triangle.
► Switch on the ignition (without starting the
engine).
► Wait around 1 minute and switch off the
ignition.
► Operate the starter motor to start the engine.
If the engine does not start at the first attempt,
do not keep trying, but restart the procedure.
Storage compartment
Tool kit
Set of tools supplied with the vehicle.
Its content depends on your vehicle's equipment:
– Temporary puncture repair kit.
– Spare wheel.
For versions supplied with a triangle as original
equipment, refer to the illustration above.
For other versions, refer to the assembly
instructions provided with the triangle.
► Put the triangle in place behind the vehicle,
as required by local legislation.
Access to the tools
Depending on version, the tool kit is stored in a
bag or in a storage box in the boot.
Running out of fuel
(Diesel)
With Diesel engines, the fuel system must be
primed if you run out of fuel.
There is a compartment in the interior trim of the
tailgate to store a warning triangle.
► After opening the tailgate, release the cover
by turning the screw a quarter turn to the left.
Before starting to prime the system, it is
essential to put at least 5 litres of Diesel into the
fuel tank.
163
In the event of a breakdown
On the boot carpet or floor
With temporary puncture repair kit
workshop to obtain the one that was intended
by the manufacturer.
The jack meets European standards, as
defined in the Machinery Directive 2006/42/
CE.
The jack does not require any maintenance.
List of tools
With spare wheel
1. Chock to immobilise the vehicle (depending
on equipment)
2. Socket for the wheel security bolts (located in
the glove box) (depending on equipment)
To adapt the wheelbrace to the special
‘security’ bolts.
Under the boot carpet or floor
► Raise the boot floor (depending on version),
then the boot carpet by pulling the strap to
access the tools.
These tools are specific to the vehicle
and may vary according to the level of
equipment.
3. Removable towing eye
For more information on Towing the vehicle
and using the removable towing eye, refer to the
corresponding section.
Do not use them for any other purpose.
The jack must only be used to change a
wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with the vehicle.
If the vehicle does not have its original jack,
contact a PEUGEOT dealer or a qualified
164
In the event of a breakdown
With temporary puncture repair kit
Tyre inflation pressures are indicated on
this label.
For more information on Identification
markings, particularly this label, refer to the
corresponding section.
5. Wheelbrace
8
For removing the wheel bolts.
6. Jack with integrated handle
To raise the vehicle.
7. Wheel bolt cap removal tool (depending on
equipment)
For removing the wheel bolt head finishers on
alloy wheels.
For more information on the Spare wheel, refer
to the corresponding section.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
4. 12 V compressor with cartridge of sealant
and speed limit sticker
Temporary puncture
repair kit
For more information on Tyre under-inflation
detection, refer to the corresponding section.
For temporary repair of a tyre and to adjust
the tyre pressure.
Scan the QR Code on page 3 to view
explanatory videos.
For more information about the Temporary
puncture repair kit, refer to the corresponding
section.
Repair procedure
Do not remove any foreign bodies (e.g.
nail, screw) which have penetrated into
the tyre.
Made up of a compressor and a sealant
cartridge, it allows you to carry out a temporary
repair of the tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures located
on the tyre tread.
With spare wheel
► Park the vehicle without obstructing traffic
and apply the parking brake.
► Follow the safety instructions (hazard
warning lamps, warning triangle, high visibility
jacket, etc.) according to the legislation in force
in the country in which you are driving.
► Switch the ignition off.
The vehicle's electric system allows the
connection of the compressor to the 12 V
power supply for long enough to repair a tyre
after a puncture.
► Remove the valve cap from the tyre to be
repaired, and place it in a clean place.
For more information on the Tool kit,
refer to the corresponding section.
165
