Deutsch
EnglishPractical Information -> Changing a Wheel for your Peugeot 107 2005-2014
PRACTICAL INFORMATION
9
Tools
CHANGING A WHEEL
The following tools are installed in a
carrier, located in the centre of the
spare wheel:
1. Wheelbrace
2. Jack with handle
3. Removable towing eye
Parking the vehicle
As far as possible, immobilise the
vehicle on level, stable, non-slip-
pery ground.
Access to the spare wheel and
the jack in the boot
Apply the handbrake, switch
off the ignition and engage first
gear, reverse or position N for the
"2 Tronic" gearbox.
Remove the carpet then the plas-
tic cover using the handle.
If necessary, chock the wheel di-
agonally opposite the wheel to be
changed.
Tyre pressure
This is indicated on the label posi-
tioned on the interior pillar of the left
door, see "Identification".
68
PRACTICAL INFORMATION
9
Removing the wheel
Refitting the wheel
Remove the trim.
Position the wheel.
Release the wheel bolts using the
wheelbrace 1.
Screw in the bolts fully by hand.
Place the jack 2 in contact with one
of the four locations A provided on
the underframe, the one closest to
the wheel to be changed.
Extend the jack 2 until its base
is in contact with the ground. En-
sure that the centreline of the jack
base is directly below the location
A used.
Lift the vehicle.
Remove the bolts and detach the
wheel.
Pre-tighten* using the wheelbrace 1.
* If your vehicle is fitted with alloy wheels, when tightening the bolts it is normal
to notice that the washers do not come into contact with the spare wheel. It is
fixed securely.
69
