Deutsch
EnglishInstruments and Controls for your Peugeot 107 2005-2014
INSTRUMENTS AND CONTROLS
1
DISPLAY
"2 Tronic" gearbox indicator
Lever in EASY mode
(automatic mode)
"E" is displayed when this
Total/trip distance recorder
When the ignition is switched on,
the distance recorder selected
when the engine was switched off is
displayed.
operating mode is selected.
To reset the trip recorder to zero,
when it is displayed, press and hold
button 1.
It is switched off on switching to
manual mode.
Press button 1 to alternate the
distance display:
- total with "ODO" displayed,
- trip with "TRIP" displayed.
Lever in manual mode
"M" is displayed when this
operating mode is selected.
It is switched off on
switching to EASY mode.
"Neutral"
"Reverse"
20
INSTRUMENTS AND CONTROLS
1
DISPLAY
"2 Tronic" gearbox indicator
Lever in EASY mode
(automatic mode)
"E" is displayed when this
Total/trip distance recorder
When the ignition is switched on,
the distance recorder selected
when the engine was switched off is
displayed.
operating mode is selected.
To reset the trip recorder to zero,
when it is displayed, press and hold
button 1.
It is switched off on switching to
manual mode.
Press button 1 to alternate the
distance display:
- total with "ODO" displayed,
- trip with "TRIP" displayed.
Lever in manual mode
"M" is displayed when this
operating mode is selected.
It is switched off on
switching to EASY mode.
"Neutral"
"Reverse"
20
INSTRUMENTS AND CONTROLS
1
Operating mode:
1st gear
Running out of diesel fuel
After running out of fuel, you
can travel a short distance
after 10 pump repriming op-
erations (see corresponding
section).
After filling the fuel tank (minimum
5 litres), operate the repriming pump
at least 10 times (see corresponding
section).
2nd gear
3rd gear
4th gear
5th gear
Fuel gauge
This indicates the quantity of fuel
available:
1/1 and six blocks, the fuel tank is full.
-
- R and one block flashing, the fuel
tank is on the reserve.
Low fuel level
When the minimum level in the fuel
tank is reached, the last block flashes
accompanied by an audible signal.
In certain driving conditions and depend-
ing on the engine, the distance which
can be travelled with the fuel remaining
may be less than 30 miles (50 km).
You have approximately 5 litres
remaining.
"!" warning light
If this warning light comes
on, with the engine running,
this indicates a malfunction
of the "2 Tronic" gearbox.
When the frequency of the flashing
increases, you have approximately
3 litres remaining.
Contact a PEUGEOT dealer.
At least 5 litres must be add-
ed after running out of fuel.
21
AUDIO EQUIPMENT
2
GENERAL NOTES/ADJUSTMENTS/AUXILIARY SOCKET
Clock adjustment: press for more
than 2 seconds/Access to the
audio settings
Selection of the source: auxiliary
(or CD or CD changer)
On/Off
Hours adjustment/Audio settings
Auxiliary socket for portable
equipment (MP3 player, ...)
Minutes adjustment/Audio
settings
Volume adjustment
22
AUDIO EQUIPMENT
2
GENERAL FUNCTIONS
On/off
VOLUME ADJUSTMENT
AUXILIARY SOCKET
Press the upper part
An auxiliary socket
"AUX" is provided for
the connection of port-
able equipment (MP3
player, etc.).
of this button several
times in succession to
increase the volume
of the audio equip-
ment or the lower part
of this button to de-
crease it.
With the ignition key
in the accessories
position or with the
ignition on, press this button to switch
the audio equipment on or off.
After the engine has been switched
off, the audio equipment can only
operate for approximately 30 min-
utes, to prevent discharging of the
battery.
In order to listen to it,
connect your equip-
ment then press this
button.
The audio equipment controls enable
you to adjust the volume and the
audio settings.
To exit from the AUX source, press
AM/FM.
CLOCK ADJUSTMENT
AUDIO SETTINGS
Press this button for
more than 2 seconds,
the clock display
flashes:
Press this button sev-
eral times in succes-
sion to gain access
to the bass (BASS),
treble (TREB), front/rear balance
(FAD) and left/right balance (BAL)
settings.
- to adjust the hours,
press this button,
-
to adjust the minutes,
press this button.
When the parameter
is displayed, change
the setting using these
two buttons.
You exit from this mode automati-
cally after a few seconds without any
action.
You exit from this mode automati-
cally after a few seconds without any
action.
23
