Deutsch
EnglishKey, locks and alarm -> Alarm for your Volvo XC60 2017-2026
KEY, LOCKS AND ALARM
Alarm
Alarm indicator
In the event of alarm system failure
If a problem is detected in the alarm
system, a symbol and the message
Alarm system failure Service
The alarm emits sound and light signals if
anyone without a valid remote key attempts
to break into the vehicle or interferes with the
start battery or alarm siren.
required will appear in the instru-
ment panel. Contact a workshop - an author-
ized Volvo workshop is recommended.
When armed, the alarm will be triggered if:
the hood, tailgate or any door is opened.
a battery cable is disconnected.
the alarm siren is disconnected.
•
•
•
Do not attempt to repair or alter any of the
components in the alarm system yourself.
Any such attempt could affect the terms
and conditions of your insurance policy.
Alarm signals
The following occurs if the alarm is triggered:
A siren will sound for 30 seconds or until
the alarm is turned off.
•
A red indicator light on the dashboard shows
the status of the alarm:
Related information
The hazard warning flashers will flash for
5 minutes or until the alarm is turned off.
•
Indicator off - the alarm is disarmed.
•
•
•
Indicator flashes once every two seconds -
the alarm is armed.
If the reason the alarm was triggered is not
rectified, the alarm cycle will repeat up to 10
The indicator flashes quickly after the
alarm has been disabled for up to
•
times15
.
30 seconds or until the ignition is put in I
mode – the alarm has been triggered.
15
Certain markets only.
266
KEY, LOCKS AND ALARM
3. Turn the start knob clockwise and release.
> The alarm will be disarmed.
Arming and disarming the alarm
The alarm is armed when the vehicle is
Disarming the alarm
Unlock and disarm the vehicle alarm by
locked.
pressing the unlock button on the remote
key
grip a door handle or lightly press the tail-
gate's rubberized button16
•
•
Turning off a triggered alarm
.
Arming the alarm
Lock and arm the vehicle by
–
Press the unlock button on the remote key
or put the ignition into mode I by turning
the start knob clockwise and then releas-
ing it.
.
pressing the lock button on the remote
key
•
•
Disarming the alarm without a functioning
remote key
The vehicle can be unlocked and disarmed
even if the remote key is not functioning, e.g. if
the battery is discharged.
.
Automatically arming and disarming
the alarm
Automatically arming the alarm helps prevent
inadvertently leaving the vehicle without alarm
protection.
touch the marked surface on the outside
of the door handle or the rubberized pres-
sure plate on the tailgate16
.
If the vehicle is equipped with both keyless
locking/unlocking* and power tailgate*, the
1. Open the driver's door using the detacha-
ble key blade.
If the vehicle is unlocked using the remote key
(and the alarm is disarmed) but none of the
doors or tailgate are opened within two
minutes, the alarm will be automatically
rearmed. The vehicle will also re-lock.
button
on the lower edge of the tailgate
> This will trigger the alarm.
can also be used to lock and arm the vehicle.
On some markets, the alarm will be automati-
cally armed following a slight delay after the
driver's door has been opened and closed
without being locked.
To change this setting:
1.
Tap Settings in the center display's Top
view.
Location of the backup key reader in the cup holder.
2. Place the remote key on the key symbol in
the backup reader in the tunnel console's
cup holder.
2. Tap My Car Locking.
A red LED light on the dashboard will flash every
other second when the vehicle is locked and the
alarm is armed.
3.
Select Passive Arming Deactivation to
temporarily deactivate the function.
16
Vehicles with keyless locking and unlocking*.
}}
* Option/accessory. 267
DRIVER SUPPORT
