Deutsch
EnglishInstruments and controls -> Turn signal lever for your Subaru Forester 2019-2024
Turn signal lever 239
3-15. Turn signal lever
.
Turn the switch to “OFF” (for Canada
models).
For Canada models
1
2
Headlight switch
Fog light switch
1
2
3
4
Right turn
The indicator light on the combination
meter will illuminate when the front fog
lights are illuminated.
Lane change right signal
Lane change left signal
Left turn
The front fog lights will turn on when the
fog light switch is placed in the “ ” position
while the headlights are in the following
condition.
If the lever does not return after cornering,
return the lever to the neutral position by
hand.
.
The headlight switch is in the “
position with the low beam mode
selected.
For models with the auto on/off head-
lights, while the headlight switch is in
the “AUTO” position and the low beam
headlights turn on automatically.
”
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The lever will
return automatically to the neutral position
when you release it.
.
To turn off the front fog lights, perform the
following.
.
Turn the switch to “ ” (except for
Canada models).
– CONTINUED –
Wiper and washer
240
.
In freezing weather, be sure that
the blade rubbers are not frozen
to the windshield or rear window
before switching on the wipers.
Attempting to operate the wiper
with the blades frozen to the
window glass could cause not
only the blade rubbers to be
damaged but also might cause
the wiper motor to fail. If the blade
rubbers are frozen to the window
glass, be sure to operate the
defroster, windshield wiper dei-
cer (if equipped) or rear window
defogger before turning on the
wiper.
& One-touch lane changer
3-16. Wiper and washer
To flash the turn signal and turn signal
indicator light three times, push the turn
signal lever up or down slightly and
immediately release it.
WARNING
In freezing weather, do not use the
windshield washer until the wind-
shield is sufficiently warmed by the
defroster.
NOTE
The operational/non-operational
setting of the one-touch lane changer
can be changed by a SUBARU dealer.
Contact the nearest SUBARU dealer for
details. The setting can also be chan-
ged by operating the combination me-
ter display (color LCD). For details,
refer to “Vehicle Setting” �P199.
Otherwise the washer fluid can
freeze on the windshield, blocking
your view.
CAUTION
.
.
Do not operate the washer con-
tinuously for more than 10 sec-
onds, or when the washer fluid
tank is empty. This may cause
overheating of the washer motor.
Check the washer fluid level fre-
quently, such as at fuel stops.
.
If the wipers stop during opera-
tion because of ice or some other
obstruction on the window, this
might cause the wiper motor to
fail even if the wiper switch is
turned off. If this occurs,
promptly stop the vehicle in a
safe place, turn the ignition
switch to the “LOCK”/“OFF” po-
sition and clean the window glass
to allow proper wiper operation.
Do not operate the wipers when
the windshield or rear window is
dry. This may scratch the glass,
damage the blade rubbers and
might cause the wiper motor to
fail. Before operating the wiper
on a dry windshield or rear win-
dow, always use the windshield
washer.
.
Use clean water if windshield
washer fluid is unavailable. In
areas where water freezes in
winter, use SUBARU Windshield
Washer Fluid or the equivalent.
