Instruments and controls -> Fog light switch for your Subaru Forester 2019-2024
Headlight beam leveler
238
The SRH OFF indicator light on the
combination meter illuminates when SRH
is turned off.
If SRH is malfunctioning, the SRH OFF
indicator light on the combination meter
flashes when the ignition switch is in the
“ON” position. It indicates that SRH has
been deactivated. Contact a SUBARU
dealer for an inspection.
3-13. Headlight beam leveler
3-14. Fog light switch (if
equipped)
The LED headlights produce more light
than conventional halogen headlights.
When the vehicle is carrying a heavy load
and the headlight beams are angled
upwards, the driver of an oncoming vehicle
may experience glare.
To prevent this, the automatic headlight
beam leveler adjusts the headlights to the
optimum height automatically depending
on the load the vehicle is carrying.
NOTE
.
.
.
If you turn the ignition switch to the
“OFF” position with SRH turned off
and then start the engine again, SRH
will automatically turn on.
When you turn the ignition switch to
the “ON” position, the SRH OFF
indicator light will illuminate and
turn off after several seconds.
SRH only activates when the vehicle
is traveling forward at the speed of
approximately 5 mph (8 km/h) or
more.
CAUTION
In certain circumstances, the head-
lights may become misaligned, and
the headlight beam leveler will not
reset them to the proper angle. This
may occur after transporting your
vehicle on a flat-bed truck, or if the
vehicle is parked and restarted on
different angles. In such cases, have
the headlight alignment checked by
a SUBARU dealer.
Except for Canada models
1
2
Headlight switch
Fog light switch
Turn signal lever 239
3-15. Turn signal lever
.
Turn the switch to “OFF” (for Canada
models).
For Canada models
1
2
Headlight switch
Fog light switch
1
2
3
4
Right turn
The indicator light on the combination
meter will illuminate when the front fog
lights are illuminated.
Lane change right signal
Lane change left signal
Left turn
The front fog lights will turn on when the
fog light switch is placed in the “ ” position
while the headlights are in the following
condition.
If the lever does not return after cornering,
return the lever to the neutral position by
hand.
.
The headlight switch is in the “
position with the low beam mode
selected.
For models with the auto on/off head-
lights, while the headlight switch is in
the “AUTO” position and the low beam
headlights turn on automatically.
”
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The lever will
return automatically to the neutral position
when you release it.
.
To turn off the front fog lights, perform the
following.
.
Turn the switch to “ ” (except for
Canada models).
– CONTINUED –





