Deutsch
EnglishPractical information -> Energy economy mode for your Peugeot 2008 2019-2025
Practical information
If a telephone call is in progress at the
time, it will be maintained for around 10
minutes via the audio system’s hands-free
system.
Removing
Exiting the mode
These functions are automatically reactivated the
next time the vehicle is used.
To restore the use of these functions
For the central screen with vertical grille
► Insert a flat screwdriver into the holes to
reach the upper fixing brackets of the central
screen.
► Press on each upper fixing bracket in turn to
release them from the grille.
immediately, start the engine and let it run:
– For less than 10 minutes, to use the
equipment for approximately 5 minutes.
– For more than 10 minutes, to use the
equipment for approximately 30 minutes.
Let the engine run for the specified duration to
ensure that the battery charge is sufficient.
To recharge the battery, avoid repeatedly or
continuously restarting the engine.
For the side screen
► Insert a finger into the notch in the lower part
of the side screen.
► Pull towards you to unclip the unit.
► Pull towards you to unclip the unit.
Energy economy mode
This system manages the duration of use of
certain functions, in order to conserve a sufficient
level of charge in the battery with the ignition off.
After switching off the engine and for a maximum
cumulative period of around 30 minutes, you can
continue to use functions such as the audio and
telematics system, dipped beam headlamps or
courtesy lamps.
A flat battery prevents the engine from
starting.
For more information on the 12 V battery,
refer to the corresponding section.
For the central screen with horizontal grille
► Press the upper fixing brackets to release
them from the grille.
► Gently tilt the central screen downwards.
► Pull towards you to unclip the unit.
Load reduction mode
This system manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates certain
Selecting the mode
A confirmation message is displayed when
energy economy mode is entered, and the active
functions are placed on standby.
152
Practical information
functions, such as the air conditioning and the
heated rear screen.
The deactivated functions are reactivated
automatically as soon as conditions permit.
instrument panel and disconnect the charging
nozzle if it is plugged in.
7
Bonnet
Stop & Start
The location of the interior bonnet
release lever prevents the bonnet being
opened when the left-hand front door is
closed.
Before doing anything under the bonnet,
you must switch off the ignition to avoid any
risk of the engine restarting automatically.
Take care with objects or clothing that could
be caught in the blades of the cooling fan
or in certain moving components - risk of
strangulation and serious injury!
► Pull the interior release lever, located at the
bottom of the door frame, towards you.
When the engine is hot, handle the
exterior safety catch and the bonnet stay
with care (risk of burns), using the protected
area.
When the bonnet is open, take care not to
damage the safety catch.
Do not open the bonnet under very windy
conditions.
Electric motor
Take care with objects or clothing that
could be caught in the blades of the cooling
fan or in certain moving components - risk of
strangulation and serious injury!
Cooling of the engine when stopped
The engine cooling fan may start after
the engine has been switched off.
► Lift the exterior safety catch and raise the
bonnet.
Before carrying out any work under the
bonnet, you must switch off the ignition, check
that the READY indicator lamp is off on the
Take care with objects or clothing that
could be caught in the blades of the fan!
► Unclip the stay from its housing and place it
in the support slot to hold the bonnet open.
Closing
► Hold the bonnet and pull out the stay from the
support slot.
Opening
► Open the left-hand front door.
► Clip the stay in its housing.
153
