Deutsch
EnglishInstruments -> Indicators for your Peugeot 2008 2019-2025
Instruments
For more information, refer to the Driving
Sidelamps
Foot on the brake
section.
Fixed.
Fixed.
The lamps are on.
Insufficient or no pressure on the brake
Vehicle ready to drive (Electric)
Fixed, accompanied by an audible signal
when it comes on.
The vehicle is ready to drive and the thermal
comfort systems are available.
The indicator lamp goes out upon reaching a
speed of approximately 3 mph (5 km/h) and
lights up again when the vehicle stops moving.
The lamp will go out when you turn off the
engine and exit the vehicle.
pedal.
Dipped beam headlamps
Fixed.
With the EAT6 automatic gearbox, with the
engine running, before releasing the parking
brake, to move out of position P.
With the EAT8 automatic gearbox or the drive
selector, it may be necessary to depress the
brake pedal to unlock the gearbox from mode N.
This warning lamp will remain on if you attempt
to release the parking brake without depressing
the brake pedal.
The lamps are on.
Automatic headlamp dipping
Fixed.
The function has been activated
via the touch screen (Driving/Vehicle menu).
The lighting control stalk is in the "AUTO"
position.
For more information, refer to the Lighting and
visibility section.
Park Assist
Automatic gearbox (EAT8) or Drive
selector (Electric)
Fixed.
The function is active.
For more information, refer to the Driving
section.
Front foglamps
Fixed.
Fixed.
The automatic gearbox is locked.
The drive selector is locked.
You must press the Unlock button to unlock it.
The front foglamps are on.
Lane positioning assist
Fixed.
The function has been activated.
All conditions have been met: the system is
operating.
Blue warning/indicator lamps
Water in Diesel fuel filter
Main beam headlamps
Fixed.
Fixed (with LCD instrument panels).
The Diesel fuel filter contains water.
Carry out (2) without delay. Risk of damaging the
fuel injection system!
The lamps are on.
For more information, refer to the Driving
section.
Black/white warning lamps
Foot on the clutch (Petrol or Diesel)
Fixed (with LCD instrument panels).
Stop & Start: the change to START mode
is rejected because the clutch pedal is not fully
depressed.
Automatic wiping
Fixed.
Indicators
Automatic windscreen wiping is activated.
Direction indicators
Service indicator
The servicing information is expressed in terms
of distance (miles or kilometres) and time
(months or days).
Flashing with audible signal.
The direction indicators are on.
Fully depress the clutch pedal.
18
Instruments
The alert is given at whichever of these two
terms is reached first.
The servicing information is displayed in the
instrument panel. Depending on the version of
the vehicle:
– The distance recorder display line indicates
the distance remaining before the next service
is due, or the distance travelled since it was due
preceded by the "-" sign.
– An alert message indicates the distance
remaining, as well as the period before the next
service is due or how long it is overdue.
Service spanner flashing
Flashing then fixed, when the
ignition is switched on.
(With BlueHDi Diesel engines, associated with
the Service warning lamp.)
at least 5 minutes for the reset to be
registered.
1
Reminder of the servicing information
You can view the servicing information by
pressing the "Check" button in the
Driving/Vehicle touch screen menu.
The servicing interval has been exceeded.
Have your vehicle serviced as soon as possible.
Resetting the service indicator
The service indicator must be reset after each
service.
If you have serviced your vehicle yourself:
► Switch the ignition off.
Engine oil level indicator
(Depending on version)
On versions fitted with an electric gauge, the
engine oil level status is displayed on the
instrument panel for a few seconds when
the ignition is switched on, after the servicing
information.
The value indicated is calculated
according to the distance covered and
the time elapsed since the last service.
The alert may also be triggered close to a
due date.
The level read will only be correct if the
vehicle is on level ground and the engine
has been off for more than 30 minutes.
Service spanner
On temporarily when the ignition is
switched on.
Low oil level
Between 620 and 1,860 miles (1,000 and 3,000
km) remain before the next service is due.
Fixed, when the ignition is switched on.
The next service is due in less than 620
miles (1,000 km).
This is indicated by the display of "OIL" or by
the message "Oil level incorrect" (depending
on the instrument panel), accompanied by the
lighting of the Service warning lamp and an
audible signal.
If a low oil level is confirmed by a check using
the dipstick, the level must be topped up to avoid
damage to the engine.
► Press and hold the button located on the end
of the lighting control stalk.
► Without pressing the brake pedal, press the
START/STOP button once; a temporary display
window appears and a countdown begins.
► When the display indicates =0, release the
lighting control stalk button; the spanner symbol
disappears.
Have your vehicle serviced very soon.
For more information on Checking levels, refer
to the corresponding section.
If you disconnect the battery following
this operation, lock the vehicle and wait
19
Instruments
Oil gauge malfunction
– In zone B, the temperature is too high.
The associated warning lamp and the
STOP warning lamp light up in red on the
instrument panel, accompanied by the display of
a message and an audible signal.
You must stop the vehicle as soon as it is
safe to do so.
engine starting is prevented is displayed in the
instrument panel.
This is indicated by the display of "OIL_ _"
or by the message "Oil level measurement
invalid" (depending on the instrument panel),
accompanied by the lighting of the Service
warning lamp and an audible signal.
Consult a PEUGEOT dealer or a qualified
workshop.
The engine starting prevention system
required by regulations is activated
automatically once the AdBlue® tank is empty.
It is then no longer possible to start the
engine until the minimum level of AdBlue® has
been topped up.
Wait a few minutes before switching off the
engine.
In the event of a malfunction of the
electric gauge, the oil level is no longer
monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located in the engine compartment.
For more information on Checking levels,
refer to the corresponding section.
After switching off the ignition, carefully
open the bonnet and check the coolant
level.
Manual display of driving range
(With matrix instrument panel and digital
instrument panel)
While the driving range is greater than
1,500 miles (2,400 km), it is not displayed
automatically.
You can view the range information by
pressing the "Check" button in
the Driving/Vehicle touch screen menu.
For more information on Checking
levels, refer to the corresponding
section.
AdBlue® range indicators
(BlueHDi)
The Diesel BlueHDi engines are equipped with
a system that associates the SCR (Selective
Catalytic Reduction) emissions control system
and the Diesel particle filter (DPF) for the
treatment of exhaust gases. They cannot
function without AdBlue® fluid.
When the level of AdBlue® falls below the
reserve level (between 1,500 and 0 miles (2,400
and 0 km)), a warning lamp lights up when
the ignition is switched on and an estimate
of the distance that can be travelled before
Coolant temperature
indicator
Actions required related to a lack of
AdBlue®
The following warning lamps light up when the
quantity of AdBlue® is below the reserve level:
driving range of 1,500 miles (2,400 km).
Together with the warning lamps, messages
regularly remind you of the need to top up to
avoid engine starting being prevented. Refer to
the Warning and indicator lamps section for
details of the messages displayed.
With the engine running:
– In zone A, the temperature is correct.
20
Instruments
Malfunction confirmed during the
permitted driving phase (between 685
miles and 0 miles (1,100 km and 0 km))
For more information on AdBlue®
(BlueHDi) and in particular on topping
up, refer to the corresponding section.
Warning/
indicator
lamps on
Action
Remaining
range
1
If the fault indication is still displayed
permanently after 31 miles (50 km) of driving, the
fault in the SCR system is confirmed.
The AdBlue warning lamp flashes and
a message is displayed ("Emissions
control fault: starting prevented in X miles
(kms)" or "NO START IN X miles (kms)"),
indicating the driving range in miles or
kilometres.
While driving, the message is displayed every 30
seconds. The alert is repeated when switching
on the ignition.
You can continue driving for up to 685 miles
(1,100 km) before the engine starting
prevention system is triggered.
To be able
0 miles (km)
to restart the
engine, add at
least 5 litres of
AdBlue® to the
tank.
Warning/
indicator
lamps on
Action
Remaining
range
Top up.
Between
1,500 miles
and 500
Malfunction of the SCR emissions
control system
miles (2,400
km and 800
km)
Malfunction detection
Top up as
soon as
possible.
Between
500 miles
and 62
If a malfunction is detected,
these warning lamps come
on, accompanied by an
audible signal and the
display of an "Emissions
control fault" or "NO START
IN" message.
miles (800
km and
100 km)
Have it checked by a PEUGEOT dealer
or a qualified workshop.
A top-up is
vital, there is
a risk that the
engine will
be prevented
from starting.
Between 62
miles and 0
miles (100
km and 0
km)
Starting prevented
Every time the ignition is switched on, the
message "Emissions control fault: Starting
prevented" or "NO START IN" is displayed.
The alert is triggered while driving when the
fault is detected for the first time, and thereafter
when switching on the ignition for subsequent
journeys, for as long as the cause of the fault
persists.
To restart the engine
Contact a PEUGEOT dealer or a
qualified workshop.
If the fault is temporary, the alert
disappears during the next journey, after
self-diagnostic checks of the SCR emissions
control system.
21
Instruments
The state of charge of the traction battery
is critical.
Fixed, together with the reserve warning lamp,
accompanied by an audible signal.
► You must put the vehicle on charge.
Power indicator (Electric)
Charge level indicator
(Electric)
The remaining range is no longer
calculated. The drive train power
gradually decreases.
The heating and air conditioning are switched
off (even if the needle or cursor indicating
their consumption is not at the "ECO"
position).
CHARGE
Traction battery charging during deceleration
and braking.
ECO
Moderate energy consumption and optimised
driving range.
POWER
Energy consumption by the drive train during
acceleration.
NEUTRAL
On switching on the ignition, your vehicle’s
electric drive train neither consumes nor
generates energy: after sweeping over the
indicator, the needle or the cursor returns to its
"neutral" position.
The traction battery's actual charge level and
the remaining range are displayed continuously
when the vehicle is started.
Thermal comfort
consumption indicator
(Electric)
(Depending on version)
With the ignition off, opening the driver's
door activates the indicator.
Associated warning lamps
Two successive alert levels indicate that the
energy available has dropped to a low level:
1st level: Reserve
The state of charge of the traction battery
is low.
Fixed and indicator in the red zone,
accompanied by an audible signal.
► View the remaining range on the instrument
panel.
With the ignition off, opening the driver's
door activates the indicator, which moves
to the "neutral" position.
The gauge shows the consumption of the
traction battery's electrical energy by the thermal
comfort devices in the passenger compartment.
With a digital instrument panel, the gauge only
appears in "Personal" mode.
► Put the vehicle on charge as soon as
possible.
2nd level: Critical
22
