Deutsch
EnglishLighting -> Automatic High Beam Control for your Ford Focus 2010-2017
Lighting
4. The lighting control is in the autolamps
Note: Typical road dust, dirt and water
spots do not affect the performance of the
automatic high beam control. However, in
cold or inclement weather conditions, you
may notice a decrease in the availability of
the automatic high beam control, especially
at start up. If you want to change the beam
state independently of the system, you may
switch the high beams on or off using the
lighting control switch. Automatic high
beam control resumes when conditions are
correct.
position.
5. The headlamps are off.
The other lighting control switch positions
do not activate the daytime running lamps,
and you can use them to temporarily
override autolamp control.
When switched off in the information
display, the daytime running lamps are off
in all lighting control switch positions.
Note: Modification of your vehicle ride
height such as using much larger tires, may
degrade feature performance.
AUTOMATIC HIGH BEAM
CONTROL
A camera sensor, centrally mounted
behind the windshield of your vehicle,
continuously monitors conditions to decide
when to switch the high beams off and on.
The system automatically turns on the high
beams if it is dark enough and no other
traffic is present. When it detects the
headlights of an approaching vehicle, the
rear lamps of the preceding vehicle or
street lighting, the system turns off the high
beams before they distract other drivers.
The low beams remain on.
Note: If it appears that automatic high
beam is not functioning properly, check the
windshield in front of the camera for a
blockage. A clear view of the road is required
for proper system operation. Make sure that
authorized personnel repair any windshield
damage in the area of the camera's field of
view.
Note: If the system detects a blockage such
as bird droppings, bug splatter, snow or ice,
and you do not observe changes, the system
may go into low beam mode until you clear
the blockage. A message may also appear
in the information display noting the front
camera is blocked.
Once the system is active, the high beams
switch on if:
•
•
•
The ambient light level is low enough.
There is no traffic in front of the vehicle.
The vehicle speed is greater than
approximately 32 mph (52 km/h).
The high beams turn off if:
•
The system detects the headlamps of
an approaching vehicle or the rear
lamps of a preceding vehicle.
•
•
•
•
Vehicle speed falls below
approximately 27 mph (44 km/h).
The ambient light level is high enough
that high beams are not required.
The system detects severe rain, snow
or fog.
The camera is blocked.
Activating the System
Switch the system on using the information
display. See InformationDisplays (page
91). Turn the switch to the autolamps
position. See Autolamps (page 76).
78
Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing
Lighting
The indicator lamp illuminates
DIRECTION INDICATORS
to confirm when the system is
ready to assist.
Manually Overriding the System
E162681
Push the lever up or down to use the
direction indicators.
Note: Tap the lever up or down to make the
direction indicators flash three times to
indicate a lane change.
E169254
Push or pull the lever to switch between
high and low beam.
INTERIOR LAMPS
The lamps turn on when:
FRONT FOG LAMPS(If Equipped)
•
•
•
You open any door.
You press a remote control button.
You press the buttons on the map
lamps.
Front Interior Lamps (If Equipped)
Note: Press the door function switch to
switch off interior lights when you open any
door. The indicator lamp illuminates amber
when the door function is off. When the door
function is off and you open a door, the
courtesy and door lamps stay off. Press the
switch again to switch the door function
back on. The indicator lamp illuminates
white when the door function is on. When
the door function is on and you open a door,
the courtesy and door lamps switch on.
E142453
Press the control to switch the fog lamps
on or off.
You can switch the fog lamps on when the
lighting control is in any position except
Off and the high beams are not on.
79
Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing
