Deutsch
EnglishMyKey -> Settings-ST for your Ford Fiesta 2017-2023
MyKey™
Speed Limit
MYKEY SETTINGS - ST
Non-Configurable Settings
Seatbelt Reminder
The audio system mutes when the seatbelt
reminder turns on. The seatbelt reminder
cannot be switched off with a MyKey.
WARNING: Do not set MyKey
maximum speed limit to a limit that will
prevent the driver from maintaining a
safe speed considering posted speed
limits and prevailing road conditions. The
driver is always responsible to drive in
accordance with local laws and
Early Low Fuel
The low fuel level indicator turns on earlier.
prevailing conditions. Failure to do so
could result in accident or injury.
Driving and Parking Aids
You can set a speed limit for your vehicle.
Warning messages appear in the
information display and a tone sounds if
your vehicle reaches the set speed. You
cannot override the set speed when using
a MyKey.
Parking aids, blind spot information system
and cross traffic alert turn on when you
start the engine and cannot be switched
off with a MyKey.
Pre-collision assist and lane keeping alert
turn on when you start the engine, but can
be switched off with a MyKey.
A new destination in the navigation system
can only be set using voice commands,
when using a MyKey and your vehicle is
moving.
Speed Reminder
You can set a speed reminder for your
vehicle. Warning messages appear in the
information display and a tone sounds if
your vehicle exceeds the set speed.
Audio System Volume Limit
Selectable Drive Modes
The audio system maximum volume is
reduced. A message appears in the
information display if you attempt to
exceed the volume limit. Automatic
volume control turns off.
You cannot select some drive modes when
using a MyKey.
Stability Control
You cannot switch stability control off
Emergency Assistance
If you set emergency assistance to be
always on, it cannot be switched off with
a MyKey.
when using a MyKey.
Configurable Settings
You can configure the following settings
after creating a MyKey. See Creating a
MyKey (page 47).
Do Not Disturb
If you set do not disturb to be always on,
it cannot be switched off with a MyKey.
46
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
MyKey™
Stability Control
CREATING A MYKEY -
VEHICLES WITHOUT: PUSH
If you set stability control to be always on,
the reduced stability control mode cannot
be selected when using a MyKey. See
Using Stability Control (page 161).
BUTTON START
Switch the ignition on using an admin key.
To create a MyKey, use the information display controls on the steering wheel to
select the following:
Menu Item
Action
Settings
Press the menu button.
MyKey
Press the OK button.
Create MyKey
Press and hold the OK button until a confirmation message
appears in the information display.
Switch the ignition off.
Note: We recommend that you label this
key.
MyKey Information Messages
Message
Description
Key is already a MyKey
Displays when trying to create a MyKey with a key already
designated as a MyKey.
Key restricted at next
start. Label this key
Displays to confirm that the key is restricted after you switch
the ignition off.
2. Switch the ignition on.
CREATING A MYKEY -
VEHICLES WITH: PUSH
BUTTON START
1. Place an admin key in the backup
position. See Passive Key Backup
Position (page 44).
47
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
