Deutsch
EnglishDriving Aids -> Pre-Collision Assist for your Ford Fiesta 2017-2023
Driving Aids
Trip Summary
deceleration, speed and gear shifting
during the total distance traveled by your
vehicle for the current trip.
The calculated trip summary is shown as
four colored bars. The bars travel from left
to right as the calculated efficiency levels
increase. The bars indicate the average
efficiency level for acceleration,
Note: Vehicles with an automatic
transmission do not have a bar for gear
shifting.
To view the trip summary, use the information display controls on the steering
wheel to select the following:
Menu Item
MyView
Eco coach
Action
Press the menu button.
Press the OK button. Press it again to view the trip summary.
WARNING: The system may not
PRE-COLLISION ASSIST
operate properly if your vehicle has a
non-Ford windshield. Do not carry out
windshield repairs in the area around the
sensor.
WARNING: You are responsible for
controlling your vehicle at all times. The
system is designed to be an aid and does
not relieve you of your responsibility to
drive with due care and attention. Failure
to follow this instruction could result in
the loss of control of your vehicle,
personal injury or death.
WARNING: In situations where the
vehicle camera has limited detection
capability, this may reduce system
performance. These situations include
but are not limited to direct or low
sunlight, vehicles at night without tail
lights, unconventional vehicle types,
pedestrians with complex backgrounds,
running pedestrians, partly obscured
pedestrians, or pedestrians that the
system cannot distinguish from a group.
Failure to take care may result in the loss
of control of your vehicle, serious
personal injury or death.
WARNING: The system does not
operate during hard acceleration or
steering. Failure to take care may lead
to a crash or personal injury.
WARNING: The system may fail or
operate with reduced function during
cold and severe weather conditions.
Snow, ice, rain, spray and fog can
adversely affect the system. Keep the
front camera and radar free of snow and
ice. Failure to take care may result in the
loss of control of your vehicle, serious
personal injury or death.
WARNING:The Pre-Collision Assist
system with brake support cannot help
prevent all collisions. Do not rely on this
system to replace your judgment and the
need to maintain correct distance and
speed.
202
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Driving Aids
The pre-collision assist system is active
when your vehicle reaches a speed greater
than approximately 5 km/h (3 mph).
Pedestrian detection is active at speeds
up to 80 km/h (50 mph).
E156130
If your vehicle is rapidly approaching
another stationary vehicle, a vehicle or
cyclist traveling in the same direction as
yours, or a pedestrian within your driving
path, the system is designed to provide
three levels of functionality.
Note: The system is not designed to detect
animals.
Note: The system is not designed to detect
vehicles or cyclists that are traveling in a
different direction.
Level of Functionality
Description
Alert
When activated, a warning lamp flashes and an audible
warning sounds.
Brake support
The system is designed to help reduce the impact speed by
preparing the brakes for rapid braking. The system does not
automatically apply the brakes. If you press the brake pedal,
the system could apply additional braking up to maximum
braking force, even if you lightly press the brake pedal.
Active braking - vehicles The system is designed to apply the brakes if it detects a
without adaptive cruise crash is imminent. This may help reduce impact or avoid the
control
crash.
The system is active at speeds up to 130 km/h (80 mph).
Active braking - vehicles The system is designed to apply the brakes if it detects a
with adaptive cruise
control
crash is imminent. This may help reduce impact or avoid the
crash.
To switch active braking on or off, use the information display controls on the
steering wheel to select the following:
Menu Item
Action
Driver assist.
Press the menu button.
Press the OK button.
Press the OK button.
Pre-collision Assist
Active braking
Note: The warning lamp does not
illuminate if cruise control or adaptive cruise
control is active.
Distance Alert (If Equipped)
A warning lamp illuminates if the distance
to the vehicle ahead is small.
203
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Driving Aids
Distance Alert Sensitivity Settings
To adjust the distance alert sensitivity settings, use the information display
controls on the steering wheel to select the following:
Menu Item
Driver assist.
Action
Press the menu button.
Pre-collision Assist
Alert sensitivity
Press the OK button.
Press the OK button. Press the toggle button upward or
downward to choose your required setting. Press the OK
button.
Note: The graphic does not display if you
Distance Indication(If Equipped)
A graphical indication displays the time
gap to vehicles ahead of you traveling in
the same direction.
switch on cruise control or adaptive cruise
control.
Vehicle Speed System Sensit- Distance Indic-
Distance Gap
Time Gap
ivity
ator Color
Gray.
100 km/h
(62 mph)
Normal.
Greater than
Greater than 0.9
seconds.
25 m (82.0 ft) .
Yellow.
Red.
17–25 m
0.6-0.9
(55.8–82.0 ft).
seconds.
Less than 17 m
(55.8 ft).
Less than 0.6
seconds.
Switching Distance Indication On or Off
To switch distance indication on or off, use the information display controls on
the steering wheel to select the following:
Menu Item
Driver assist.
Action
Press the menu button.
Press the OK button.
Press the OK button.
Pre-collision Assist
Distance indication
204
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Driving Aids
The camera is mounted behind the interior
Pre-Collision Assist System
Sensors
mirror.
Vehicles without Adaptive Cruise
Control
E243054
E244279
The camera is mounted behind the interior
mirror.
The radar sensor is behind the front grille
below the license plate.
Note: Keep the sensors free from snow, ice
Note: Keep the sensors free from snow, ice
and large accumulations of dirt.
and large accumulations of dirt.
Note: Do not clean the sensors with sharp
Note: Do not clean the sensors with sharp
objects.
objects.
Note: If your vehicle sustains damage
leaving the sensors misaligned, this may
cause inaccurate measurements or false
alerts.
Blocked sensors could affect system
accuracy. A message may appear in the
information display.
Note: If your vehicle sustains damage
leaving the sensors misaligned, this may
cause inaccurate measurements or false
alerts.
Blocked sensors could affect system
accuracy. A message may appear in the
information display.
Vehicles with Adaptive Cruise Control
Pre-CollisionAssistWarningLamp
It illuminates if your vehicle
rapidly approaches another
vehicle, to warn you of the risk of
a crash with the vehicle in front of you.
It could illuminate red if the distance to the
vehicle ahead is small.
It illuminates when the system is not
available.
E243054
205
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Driving Aids
Pre-Collision Assist Information Messages
Message
Action
Pre-collision assist not
available
The system has malfunctioned. Have your vehicle checked
as soon as possible.
Pre-collision assist not
The sensors are dirty. Clean the sensors. If the message
available Sensor blocked continues to appear, have your vehicle checked as soon as
possible.
The following table lists possible causes and actions for when a blocked sensor
message may display.
Cause
Action
The surface of the radar in the radiator grille Clean the radiator grille in front of the radar
is dirty or obstructed.
or remove any obstruction.
The surface of the radar is clean but the
message remains in the display.
Wait for a short period of time. It may take
several minutes for the system to detect
that there is no obstruction.
Heavy rain, spray, snow, or fog is interfering The system is temporarily disabled. The
with the radar signals.
system should reactivate after a short
period of time when the weather conditions
improve.
The radar is misaligned.
Have your vehicle checked as soon as
possible.
The windshield in front of the camera is
dirty or obstructed.
Clean the outside of the windshield in front
of the camera.
The windshield in front of the camera is
clean but the message remains in the
display.
Wait for a short period of time. It may take
several minutes for the camera to detect
that there is no obstruction.
Excessive heat around the camera.
Wait for a short period of time. The
message should clear when the temper-
ature around the camera decreases.
206
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
