Deutsch
EnglishLighting and visibility -> Toolkit for your Citroen C5 Aircross 2017-2025
In the event of a breakdown
Versions with a spare wheel
HDi engines
Access to the tool kit
F Fill the fuel tank with at least 5 litres of
Diesel.
F Open the bonnet.
F If necessary, unclip the cover to access the
priming pump.
F Loosen the degassing bolt.
F Operate the priming pump until fuel appears
in the transparent tube.
F Retighten the degassing bolt.
F Operate the starter until the engine starts (if
the engine does not start at the first attempt,
wait around 15 seconds before trying
again).
F If the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
The main tools are stowed in the boot, under
the floor.
For access to them:
F Open the boot.
F Place the adjustable boot floor in the high
position.
F unclip the storage box by pulling it up,
F unclip the two fixings to open its cover.
F Put the cover back in place, clip it and
ensure it is clipped in.
F Close the bonnet.
All of these tools are specific to your
vehicle and may vary depending on
equipment.
Versions with a temporary
puncture repair kit
Do not use them for any other purposes.
Tool kit
This is a set of tools provided with the vehicle.
Its content depends on your vehicle's
equipment:
-
-
temporary puncture repair kit,
spare wheel.
F Unclip the two fixings to open its cover.
198
In the event of a breakdown
For more information on Towing the vehicle
and using the removable towing eye, refer to
the corresponding section.
With spare wheel
The jack must only be used to change
a wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with this vehicle.
If the vehicle does not have its original
jack, contact a CITROËN dealer or
a qualified workshop to obtain the correct
jack for it.
With temporary puncture repair
kit
The jack meets European standards,
as defined in the Machinery Directive
2006/42/CE.
The jack does not require any
maintenance.
5. Wheelbrace.
For removing the wheel trim and removing
the wheel fixing bolts.
6. Jack with integrated handle.
List of tools
Used to raise the vehicle.
7.
Wheel bolt cover remover (depending on
equipment).
4. 12 V compressor with a cartridge of
sealant and a speed limit sticker.
For temporary repair of a tyre and to
adjust the tyre pressure.
For removing the wheel bolt head finishers
on alloy wheels.
For more information on the Spare wheel, refer
to the corresponding section.
For further information about the Temporary
puncture repair kit, refer to the corresponding
section.
1. Chocks to immobilise the vehicle
(depending on equipment).
2. Socket for the security bolts (located in
the glove box) (depending on equipment).
For adapting the wheelbrace to the special
"security" bolts.
Temporary puncture
repair kit
8
3. Towing eye and tool to open the protective
Scan the QR Code on page 3 to view
explanatory videos.
covers of the front and rear screw threads.
199
