Deutsch
EnglishOpening and closing -> Fixed glass roof for your BMW i5 2023-2025
Opening and closing
CONTROLS
Initialization begins within 15 seconds.
Closing from the lifted position without
the anti-trap mechanism
▷
▷
▷
If the glass sunroof is closed, it opens then
closes again.
In case of danger from the outside or if icing
might prevent normal closing, proceed as fol-
lows:
If the glass sunroof is open, it first closes,
then opens and closes again.
The sun protection is initialized in the
closed position.
Initialization is complete once the glass sun-
roof and the sun protection have opened then
closed again.
1. Close all doors.
2. Switch on drive-ready state or stop a mov-
ing vehicle.
Fixed glass roof
3. Push the switch forward past the resistance
point and hold.
General
The glass sunroof sun protection can be
opened or closed.
Initializing after a power interruption
The sun protection opens from rear to front.
General information
After a power interruption during the opening
or closing process, the glass sunroof can only
be operated to a limited extent. Initializing the
system can help in this case.
With the vehicle key
Opening the sun protection
Press and hold the button on the vehi-
cle key after unlocking.
The system can be initialized under the follow-
ing conditions:
▷
The vehicle is parked in a horizontal posi-
tion.
The glass sunroof sun protection is opened
as long as the button on the vehicle key is
pressed.
▷
The vehicle will not be moved until the initi-
alization is completed.
Closing the sun protection
▷
▷
The drive-ready state is established.
With Comfort Access: press and hold
the button on the vehicle key in close
range of the vehicle after locking.
The outside temperature is above
41 ℉/5 ℃.
During initialization, the glass sunroof closes
without the anti-trap mechanism.
The glass sunroof sun protection is closed
as long as the button on the vehicle key is
pressed.
Make sure that the closing path is clear.
Initializing the system
Depending on the vehicle equipment, exterior
mirrors are folded in unless they were folded
in while locking. The exterior mirrors are not
folded in when the hazard warning flashers are
switched on.
Press the switch up and hold
it until the initialization is com-
plete:
105
Online Edition for Part no. 01405B37D97 - II/24
Opening and closing
CONTROLS
folded in when the hazard warning flashers are
switched on.
On the door handle
Principle
Inside the vehicle
Functional requirements
The sun protection can be operated under the
following conditions:
The sun protection can be closed using the
door handle without operating the vehicle key.
The vehicle key is automatically detected near
the vehicle.
▷
▷
Standby state is switched on.
General information
The function is available with Comfort Access.
Drive-ready state is switched on.
The vehicle key must be inside the vehicle.
Button in the headliner
Overview
Depending on the country, the sun protection
can also be closed with the door handle using
a compatible smartphone and a digital key.
Additional information:
BMW Digital Key, refer to page 91.
Functional prerequisites
▷
Carry the vehicle key with you, for instance
in your pants pocket.
▷
Bluetooth must be activated on the smart-
phone to close the sun protection using the
digital key.
Closing the sun protection
Opening/closing the sun protec-
tion.
Operation
▷
Slide switch back to the re-
sistance point and hold.
The sun protection is closed
as long as the switch is held
down.
Touch the grooved surface on the door handle
of a closed front door with your finger and hold
it there without grasping the recessed grip.
▷
▷
Slide switch forward to the resistance point
and hold.
Besides locking the vehicle, the windows and
sun protection will be closed and locked.
Holding down the switch opens the sun
protection.
Depending on the vehicle equipment, exterior
mirrors are folded in unless they were folded
in while locking. The exterior mirrors are not
Slide the switch back past the resistance
point.
106
Online Edition for Part no. 01405B37D97 - II/24
Opening and closing
CONTROLS
The sun protection closes automatically.
Pressing the switch again stops the motion.
The system can be initialized under the follow-
ing conditions:
▷
▷
▷
The vehicle is parked in a horizontal posi-
tion.
▷
Push the switch forward past the resistance
point.
The vehicle will not be moved until the initi-
alization is completed.
The sun protection opens automatically.
Pressing the switch again stops the motion.
The drive-ready state is established.
Push switch up.
During initialization, the glass sunroof closes
without the anti-trap mechanism.
The sun protection moves to a
defined position to provide par-
tial shading.
Make sure that the closing path is clear.
Initializing the system
Pressing the switch again closes
the sun protection.
Press the switch up and hold
it until the initialization is com-
plete:
Control display
Operation
Initialization begins within 15 seconds.
1.
Apps menu
▷
If the sun protection is closed, it opens then
closes again.
2. "Vehicle"
3. "Doors and windows"
4. "Sun blinds"
▷
If the sun protection is open, it closes first,
then opens and closes again.
5. Select the desired function.
Initialization is complete once the sun protec-
tion has opened then closed again.
Closing the sun protection
automatically
The sun protection closes automatically when
the vehicle is locked.
When the vehicle is unlocked, the sun protec-
tion moves to its last position.
This function can be deactivated in the set-
tings, depending on vehicle equipment.
Additional information:
Settings, refer to page 95.
Initializing after a power interruption
General information
If the power is interrupted while opening or
closing, the sun protection can only be oper-
ated to a limited extent. Initializing the system
can help in this case.
107
Online Edition for Part no. 01405B37D97 - II/24
