Wheels and tires -> Tire tread for your BMW i4 2021-2025

Wheels and tires  
MOBILITY  
Temperature A B C  
car tires must meet under the Federal Motor  
Vehicle Safety Standard No. 109. Grades Band  
A represent higher levels of performance on  
the laboratory test wheel than the minimum  
required by law.  
All passenger vehicle tires must conform to  
Federal Safety Requirements in addition to  
these grades.  
Treadwear  
Warning  
The treadwear grade is a comparative rating  
based on the wear rate of the tire when tested  
under controlled conditions on a specified gov-  
ernment test course. E.g., a tire graded 150  
would wear one and one-half, 1 g, times as  
well on the government course as a tire graded  
100. The relative performance of tires depends  
upon the actual conditions of their use, how-  
ever, and may depart significantly from the  
norm due to variations in driving habits, service  
practices and differences in road characteris-  
tics and climate.  
The temperature grade for this tire is estab-  
lished for a tire that is properly inflated and  
not overloaded. Excessive speed, underinfla-  
tion, or excessive loading, either separately  
or in combination, can cause heat buildup  
and possible tire failure. There is a risk of  
accident, injury, and property damage.  
Runflat tires  
Runflat tires, refer to page 311, are labeled  
with a circular icon containing the letters RSC  
marked on the tire sidewall.  
Traction  
The traction grades, from highest to lowest,  
are AA, A, B, and C.  
M+S  
Those grades represent the tire's ability to  
stop on wet pavement as measured under  
controlled conditions on specified government  
test surfaces of asphalt and concrete. A tire  
marked C may have poor traction perform-  
ance.  
Winter tires, as well as all-season tires with  
better winter performance than summer tires,  
can be identified by the M+S marking on the  
tire side wall.  
Tire tread  
Safety information  
Warning  
The traction grade assigned to this tire is  
based on straight-ahead braking traction tests,  
and does not include acceleration, cornering,  
hydroplaning, or peak traction characteristics.  
Temperature  
If the tire tread depth is too low, driving  
safety may be impaired in critical situations  
such as aquaplaning or slush on the road.  
There is a risk of accident, injury, and prop-  
erty damage. The tire tread depth may not  
fall below 0.12 in/3 mm for summer tires and  
0.16 in/4 mm for winter and all-season tires,  
or observe the statutory regulations on mini-  
mum tread depth.  
The temperature grades are A, the highest, B,  
and C, representing the tire's resistance to the  
generation of heat and its ability to dissipate  
heat when tested under controlled conditions  
on a specified indoor laboratory test wheel.  
Sustained high temperature can cause the  
material of the tire to degenerate and reduce  
tire life, and excessive temperature can lead to  
sudden tire failure. The grade C corresponds  
to a level of performance which all passenger  
307  
Online Edition for Part no. 01405B45E30 - VI/24  
Wheels and tires  
MOBILITY  
Minimum tread depth  
Safety information  
Warning  
Damaged tires can lose tire inflation pres-  
sure, which can lead to loss of vehicle con-  
trol. There is a risk of accident, injury, and  
property damage. If tire damage is suspected  
while driving, immediately reduce speed and  
stop. Have wheels and tires checked. To do  
so, drive carefully to an authorized service  
center or another qualified service center or  
repair shop. Have the vehicle towed or trans-  
ported as needed. Do not repair damaged  
tires, but have them replaced.  
The tire manufacturer’s wear indicators are  
distributed over the tire circumference. These  
indicators have a height of min. 0.06 in/1.6 mm  
and serve as an indicator for tire tread wear.  
The positions of the wear indicators are  
marked on the tire sidewall with TWI, Tread  
Wear Indicator.  
Warning  
The wheels, tires and chassis components  
can become damaged when driving over  
curbs, road damage, or other obstacles.  
Larger wheels have a smaller tire cross-sec-  
tion. The smaller the tire cross-section, the  
higher the risk of tire damage. There is a risk  
of accident, injury, and property damage. If  
possible, avoid driving over curbs, road dam-  
age or other obstacles, or drive over them  
slowly and carefully.  
Tire damage  
General information  
Check your tires regularly for damage, foreign  
objects lodged in the tread, and tread wear.  
Indications of tire damage or another vehicle  
malfunction:  
Unusual vibrations.  
Unusual tire or running noises.  
Exchanging wheels and  
tires  
Unusual vehicle handling such as a strong  
tendency to pull to the left or right.  
Uneven wear pattern, e.g., increased wear  
in the area of the tire shoulder.  
Mounting and wheel balancing  
Have the wheel mounted and balanced by an  
authorized service center or another qualified  
service center or repair shop.  
Damage can be caused by the following situa-  
tions, for instance:  
Driving over curbs.  
Road damage.  
Suitable wheels and tires  
Tire pressure too low.  
Vehicle overloading.  
Incorrect tire storage.  
General information  
Only certain wheel/tire combinations are suit-  
able depending on vehicle and equipment.  
308  
Online Edition for Part no. 01405B45E30 - VI/24