Deutsch
EnglishDRIVING TIPS -> Things to remember when driving for your BMW 7 Series 2022-2025
Things to remember when driving
DRIVING TIPS
Things to remember when driving
Engine, transmission, and axle drive
Vehicle features and options
Up to 1,200 miles/2,000 km
Do not exceed the maximum engine and road
speed:
This chapter describes model-specific equip-
ment, systems, and functions that are currently
available, or may become available in the fu-
ture, even if they are not present in the vehicle.
▷
4,500 rpm and 100 mph/160 km/h.
Additional information:
Avoid full throttle or kickdown under all circum-
stances.
Vehicle equipment, refer to page 8.
For 760i: The maximum engine power is re-
duced and gradually increased during the first
310 miles/500 km.
Break-in procedures
General information
Moving parts need to work together smoothly.
From 1,200 miles/2,000 km
The engine and vehicle speed can gradually be
increased.
The following instructions will help you to ach-
ieve a long vehicle life and good efficiency.
Tires
During break-in, do not use the Launch Con-
trol.
Tire traction is not optimal due to manufactur-
ing circumstances when tires are brand new.
Safety information
Drive conservatively for the first
200 miles/300 km.
Warning
Brake system
Brake disks and brake pads must be broken in
to avoid possible brake noise. Drive cautiously
for the first approx. 300 miles/500 km.
Due to new parts and components, safety
and driver assistance systems can react with
a delay. There is a risk of accident, injury, and
property damage. After installing new parts
or with a new vehicle, drive conservatively
and intervene early if necessary. Observe the
break-in procedures of the respective parts
and components.
Following part replacement
Observe the break-in procedures again if com-
ponents mentioned above are replaced.
318
Things to remember when driving
DRIVING TIPS
Driving at high speeds
General driving notes
Warning
Closing the trunk lid
Damage to vehicle components can nega-
tively impact handling at high speeds. This
includes, among other things, tires, under-
body and parts for improving aerodynamics.
There is a risk of accident, injury, and prop-
erty damage. Have damage corrected by an
authorized service center or another qualified
service center or repair shop. Do not drive at
high speeds until the damage is corrected.
Safety information
Warning
An open trunk lid protrudes from the vehicle
and can endanger occupants and other road
users or damage the vehicle in the event of
an accident, braking or evasive maneuvers.
In addition, exhaust gas or water may enter
the vehicle interior. There is a risk of injury
and risk of property damage. Do not drive
with the trunk lid open.
Hot exhaust system
Warning
Driving with the trunk lid open
If the vehicle still needs to be driven with the
trunk lid open:
High temperatures can occur underneath the
body, for instance caused by the exhaust
system, while driving. Contact with the ex-
haust system can cause burns. There is a risk
of injury. Do not touch the exhaust system,
including the exhaust pipe, when hot.
▷
▷
▷
▷
Close all windows.
Greatly increase the blower output.
Drive moderately.
Secure the trunk lid, e.g., with a tensioning
belt.
Warning
If combustible materials such as leaves or
grass come in contact with hot parts of the
exhaust system, these materials can ignite.
There is a risk of fire and an injury hazard.
Do not remove the heat shields installed and
never apply undercoating to them. Make sure
that no combustible materials can come in
contact with hot vehicle parts while driving, in
Neutral or during parking.
Ground clearance
NOTICE
If the ground clearance is insufficient,
e.g., underground garage entrances, speed
bumps, or curbs, the ground may come
into contact with vehicle parts, e.g., spoiler,
and the underbody. There is a risk of prop-
erty damage. Ensure that there is sufficient
ground clearance available. Adjust your driv-
ing style to the respective conditions.
Exhaust gas particulate filter
Principle
The exhaust gas particulate filter collects soot
particles. The soot particles are burned at high
319
Things to remember when driving
DRIVING TIPS
temperatures to clean the exhaust gas particu-
late filter as necessary.
▷
▷
▷
Deactivate the speed control system.
Activate Sport Mode via My Modes.
If possible, drive at varying speeds.
General information
Additional information:
My Modes, refer to page 140.
Depending on vehicle equipment and national-
market version, the vehicle is equipped with
an exhaust particulate filter. For more informa-
tion on the exhaust particulate filter, contact an
authorized service center or another qualified
service center or repair shop.
▷
Attachment point for radio systems
The following may occur when cleaning for
several minutes:
▷
▷
▷
The combustion engine may not run as
smoothly for a short time.
A somewhat higher RPM is necessary to
reach usual power development.
Fuel consumption may be higher. The
higher fuel consumption is included as
mean value in the display for the current
consumption.
With climate comfort windshield: the marked
area is not covered with heat-reflective coat-
ing.
The marked area can be used for the attach-
ment of radio systems, e.g.:
▷
▷
The exhaust system is emitting a small
amount of smoke, even after the engine is
shut off.
▷
▷
▷
Garage door opener.
There is audible noise, e.g., radiator fan is
running, even several minutes after the en-
gine is shut off.
Electronic fee collection devices.
Payment systems.
Overrun of the radiator fan for several minutes
is normal even after short trips.
Climate comfort laminated safety
glass
Condensation in drive system
The climate comfort laminated glass provides
protection against the harmful effects of ultra-
violet radiation on the skin.
Various driving profiles ensure that the drive
system functions properly. A driving style with
consistently low loads can negatively affect
overall functionality, e.g., condensation forming
in the drive system. Occasionally running the
engine longer with higher loads can counteract
this.
It also reduces heat radiation, meaning that
the vehicle interior becomes less hot due to
sunlight.
If condensation has formed in the drive sys-
tem, a corresponding Check Control message
appears. In this case, on the next drive outside
of town, proceed as follows for approx. 30 mi-
nutes:
320
Things to remember when driving
DRIVING TIPS
▷
▷
Drive through water only up to a maximum
height of 9.8 inches/25 cm.
Mobile communications in the
vehicle
Drive through water at a maximum of walk-
ing speed, up to 3 mph/5 km/h.
Warning
Additional information:
Vehicle electronics and mobile communica-
tion devices can influence one another. There
is radiation due to the transmission oper-
ations of mobile communication devices.
There is a risk of injury and risk of property
damage. If possible, only use mobile commu-
nication devices, e.g., mobile phones, when
connected directly to an external antenna or
Personal eSIM in order to prevent mutual in-
terference and to deflect radiation from the
vehicle interior.
Auto Start/Stop function, refer to page 132.
Safety information
NOTICE
When driving too quickly through deep water,
the water can penetrate the engine compart-
ment, the electrical system, or the transmis-
sion. There is a risk of property damage.
When driving through water, do not exceed
the maximum indicated water level and the
maximum speed for driving through water.
Aquaplaning
On wet or slushy roads, a wedge of water can
form between the tires and road surface.
Braking safely
This phenomenon is referred to as aquaplan-
ing. It is characterized by a partial or complete
loss of contact between the tires and the road
surface, ultimately undermining your ability to
steer and brake the vehicle.
General information
The vehicle is equipped with an Antilock Brak-
ing System as a standard feature.
Perform full braking when appropriate. To ach-
ieve the best possible braking assistance, do
not reduce the pressure on the brake pedal
during full braking. Steering is still responsive.
You can still avoid any obstacles with a mini-
mum of steering movement.
Driving through water
General information
When driving through water, follow the follow-
ing:
Sounds from the hydraulic circuits indicate that
the Antilock Braking System is regulating.
▷
Only drive through when the combustion
engine is running.
Objects in the travel path of the pedals
▷
To prevent the combustion engine from
switching off, deactivate the Auto Start/
Stop function, e.g., engage selector lever
position S.
Warning
Objects in the driver's footwell can limit the
pedal travel or block a depressed pedal.
There is a risk of accident, injury, and prop-
erty damage. Stow objects in the vehicle such
that they are secured and cannot enter into
the driver's footwell. Use floor mats that are
suitable for the vehicle and can be safely at-
▷
▷
The combustion engine also does not shut
off in selector lever position R.
Drive through calm water only.
321
Things to remember when driving
DRIVING TIPS
tached to the floor. Do not use loose floor
mats and do not layer several floor mats.
Make sure that there is sufficient clearance
for the pedals. Ensure that the floor mats
are securely fastened again after they were
removed, for instance for cleaning.
erty damage. Avoid placing excessive stress
on the brake system.
Warning
In Neutral or with drive-ready state switched
off, safety functions, for instance engine brak-
ing effect, braking assistance and steering
assistance, may be restricted or not availa-
ble. There is a risk of accident, injury, and
property damage. Do not attempt to drive in
Neutral or with drive-ready state switched off.
Pedal feel when driving off
After turning on drive-ready state from idle
state, the pedal may feel unusual, e.g., the
pedal travel path may feel short or long. After
the brake pedal has been fully released, the
pedal will feel as usual again.
Brake disk corrosion
Corrosion on the brake disks and contamina-
tion on the brake pads are increased by the
following circumstances:
Driving in wet conditions
In case of wet roads, exposure to road salt or
in heavy rain, gently depress the brake pedal
every few kilometers. Ensure that this action
does not endanger other road users.
▷
▷
▷
▷
Low mileage.
Extended stationary periods.
Infrequent use of the brakes.
The heat generated while braking dries brake
disks and brake pads and protects them
against corrosion.
Aggressive, acidic, or alkaline cleaning
agents.
In this way the brake power will be available
when you need it.
Corrosion buildup on the brake disks will cause
a pulsating effect on the brakes when braking
slowly - generally this cannot be corrected.
Hills
General information
Condensation water under the
parked vehicle
When using the automatic climate control, con-
densation water develops and collects under-
neath the vehicle.
Drive long or steep downhill gradients in the
gear that requires least braking effort. Other-
wise, the brake system may overheat and re-
duce braking effect.
You can increase the engine braking effect by
downshifting, going all the way to first gear, if
needed.
Pennant holder
Safety information
Safety information
NOTICE
Warning
The vehicle, pennant holder, and pennant it-
self may be damaged when driving at high
speeds with a pennant attached. There is a
risk of property damage. Do not exceed a
Light but constant pressure on the brake
pedal can lead to high temperatures, brake
wear, and even failure of the brake system.
There is a risk of accident, injury, and prop-
322
Things to remember when driving
DRIVING TIPS
speed of 80 mph / 130 km/h. Remove pen-
nant before trips at high speeds.
The vehicle manufacturer recommends using
special sport tires, e.g., high-performance tires.
Sports tires are matched to the special require-
ments of a sporty driving style. For more infor-
mation on sport tires, contact an authorized
service center or another qualified service cen-
ter or repair shop.
Overview
Before and after driving on a racetrack, have
the vehicle checked by an authorized service
center or another qualified service center or
repair shop.
The pennant holder is located on the side of
the vehicle.
Installation
1. Remove the protective cap.
2. Insert pennant horizontally.
3. Turn the pennant clockwise by 90° to re-
tain the pennant.
Driving on racetracks
Warning
The vehicle is not designed for use in M Sport
or motorsport-like competition. There is a risk
of accident, injury, and property damage. Do
not use the vehicle for M Sport or motorsport-
like competitions.
Higher mechanical and thermal loads during
racetrack operation lead to increased wear.
Use of the vehicle in M Sport or motor sport
type competition is an improper use of the ve-
hicle and may affect your warranty coverage.
Please consult the New Vehicle Limited War-
ranty Booklet for further information on war-
ranty matters.
323
