Controls and features -> Tire Pressure Control (RDC) for your BMW 7 Series 2001-2007

98nTire Pressure Control (RDC)*  
The concept  
Loss of tire pressure  
RDC monitors the tire pressures at all  
four wheels, even when the vehicle is  
moving. The system provides an alert  
whenever the inflation pressure drops  
significantly below the specified pres-  
sure in one or more tires.  
If, after a certain period of time, the air  
pressure has gone down significantly  
(which is normal for any tire), the mes-  
sage "CHECK TIRE PRESSURE" ap-  
pears in the Check Control.  
This alerts you that you should have the  
tires inflated to the specified pressures  
as soon as possible.  
In order for the RDC to "learn" the cor-  
rect tire inflation pressure, check the in-  
flation pressure in all tires. Refer to the  
table of "Tire inflation pressures" on  
page 29 and make corrections if neces-  
If you are prompted to check the  
tire pressure shortly after a cor-  
Activate the system  
sary. Then activate the system.  
rection has been made, this indicates  
that the corrected values were not ac-  
curate. Please check the inflation pres-  
sure again and make corrections ac-  
cording to the inflation pressure table.<  
1 Turn the ignition key to position 2  
(do not start the engine)  
The Check Control will inform you if the  
tire pressure is not correct.  
2 Press and hold the button (arrow) un-  
til the message "SET TIRE PRES-  
SURE" appears in the Check Control  
3 After you have driven for a few min-  
utes, the RDC will import the current  
inflation pressure in the tires as the  
target values which the system will  
monitor.  
You will only have to repeat this proce-  
dure if the tire inflation pressure must  
be corrected. Otherwise, the RDC func-  
tions automatically when the ignition  
key is in position 2, and thus operates  
whenever the vehicle is driven.  
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW Group  
Tire Pressure Control (RDC)*  
99n  
The RDC cannot alert you to se-  
vere and sudden tire damage  
caused by external factors.<  
Flat tire  
System interference  
If there is a tire failure with a loss of air  
During the period of the malfunction,  
the message "TIRE CONTROL INAC-  
TIVE" appears in the Check Control.  
pressure, the message "TIRE DEFECT"  
appears in the Check Control. In addi-  
tion, a gong sounds.  
Have the tires changed by your  
BMW center.  
You will also see the same message  
If this occurs, reduce vehicle speed im-  
mediately and stop the vehicle in a safe  
location. Avoid hard brake applications.  
Do not oversteer. Replace the wheel  
and flat tire.  
> in the event of a system fault  
> if a wheel is mounted without the  
RDC electronics  
Your BMW center has been trained to  
work with the RDC system and is  
equipped with the necessary special  
tools to do so.<  
> if, in addition to the spare tire, addi-  
tional wheels with RDC electronics  
are on board.  
The spare tire which is available in  
your vehicle as standard equip-  
ment is equipped with the electronics  
required for RDC and, following activa-  
tion of the system, is also monitored af-  
ter it is mounted.<  
Please contact your BMW center for  
additional information.  
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW Group