Controls and features -> Check Control for your BMW 7 Series 2001-2007

Check Control  
79n  
> STOP! ENGINE OILPRESS  
Oil pressure too low. Stop the vehicle  
and switch off the engine immedi-  
ately. Refer to page 20.  
> CHECK BRAKE FLUID  
Indicates that brake fluid is down to  
roughly minimum level. Top up the  
brake fluid as soon as possible. Refer  
to page 152. Have the cause of the  
brake fluid loss corrected by your  
BMW center.  
> FLAT TIRE*  
Reduce vehicle speed immediately  
and stop the vehicle. Avoid hard  
brake applications. Do not oversteer.  
Refer to page 98.  
Priority 1  
System malfunctions are reported in  
text form and alerts or warnings are  
each reported by a gong when the igni-  
tion key is in position 2.  
These defects are immediately indi-  
cated by a gong and a flashing warning  
symbol (2). Several simultaneous de-  
fects will be displayed consecutively.  
These messages remain active until the  
malfunction is corrected. They cannot  
be cleared with CHECK button (1).  
> LEVEL CONTROL INACTIVE*  
Please consult the nearest BMW cen-  
ter. Refer to page 134.  
1 CHECK button  
2 Status report symbol  
3 Display  
> SPEED LIMIT*  
This is displayed if the programmed  
speed limit is exceeded.  
Messages concerning system faults are  
differentiated based on two priorities:  
> RELEASE PARKING BRAKE  
This message appears together with  
an acoustic signal any time you begin  
to drive and the parking brake is ap-  
plied.  
> COOLANT TEMPERATURE  
Coolant overheated. Stop the vehicle  
and switch off the engine immedi-  
ately.  
Refer to pages 78, 151.  
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW Group  
80nCheck Control  
Priority 2  
> TIRE PRESSURE SET*  
> TRANS. FAILSAFE PROG  
The RDC has imported the current in-  
flation pressure in the tires as the tar-  
get values which the system will  
monitor.  
Please consult the nearest BMW cen-  
ter. Refer to pages 68, 71.  
> CHECK BRAKE LININGS  
These alerts for problems are reported  
for 20 seconds when the ignition key is  
in position 2. The status reports remain  
after the message disappears. You can  
view the message again by pressing the  
CHECK button (1).  
Have the brake pads inspected by  
your BMW center. Refer to page 132.  
> CHECK COOLANT LEVEL  
Refer to page 98.  
> CHECK TIRE PRESSURE*  
Check and correct the tire inflation  
pressure to specifications at the earli-  
est opportunity (next stop for fuel).  
Refer to page 98.  
The coolant is too low. Top up at the  
next opportunity. Refer to page 151.  
> ENGINE FAILSAFE PROG  
> TRUNK LID OPEN  
This message is given only when ini-  
tially starting off.  
> DOOR OPEN  
Fault in the Electronic Engine Power  
Control EML. When braking, higher  
brake application pressure may be  
necessary and brake pedal travel  
may be significantly longer.  
> TIRE CHECK INACTIVE*  
A temporary interference of the RDC  
or a system fault. Refer to page 99.  
> BRAKE LAMP CIRCUIT  
A bulb has failed or the circuit has a  
malfunction. Refer to pages 170, 179  
or consult a BMW center.  
> CHECK LOWBEAMS  
This is displayed after a minimum  
vehicle speed is exceeded.  
> FASTEN SEAT BELTS*  
In addition, the indicator lamp with  
the safety belt symbol appears and  
an acoustic signal is heard.  
> WASHER FLUID LOW  
Please have the system inspected by  
your authorized BMW center.  
The washer fluid is too low. Top up  
the fluid at the earliest opportunity.  
Refer to page 148.  
CHECK SIDE LAMPS  
CHECK REAR LAMPS  
CHECK FRONT FOGLAMPS  
CHECK LICPLATE LAMP  
CHECK TRAILER LIGHTS  
CHECK HIGHBEAMS  
> CHECK ENGINE OIL  
Add engine oil as soon as possible.  
Refer to page 149.  
> OUTSIDE TEMPERATURE 247  
(–5.06)  
CHECK BACKUP LAMPS  
Defective bulb or circuit. Refer to  
pages 167, 179 or consult a BMW  
center.  
This display is only an example. The  
current reading appears at an outside  
temperature of 37.5 7 (+36) and  
below. Refer also to page 76.  
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW Group  
Check Control  
81n  
Displays after completion of trip  
To monitor the Check Control  
All of the malfunctions registered during With the ignition key in position 2, press  
the trip appear consecutively when the CHECK button (1):  
ignition key is turned to position 0.  
CHECK CONTROL OK appears in the  
One of the following displays may ap-  
pear:  
display.  
In this case, there are no faults in the  
systems which are monitored.  
> LIGHTS ON  
> KEY IN IGNITION LOCK  
> CHECK ENGINE OIL LEV  
Add engine oil at the next opportunity  
(next stop for fuel). Refer to page 149.  
This message appears when you open  
the driver's door after parking the vehi-  
cle. A supplementary gong is also  
heard.  
Even if the ignition key has been re-  
moved and the display has gone off,  
you can still retrieve these messages  
with CHECK button (1) for approx. three  
minutes after completion of your trip. If  
there are multiple messages, continue  
to press the CHECK button.  
Online Edition for Part No. 01 41 0 004 597 - © 08/99 BMW Group