Deutsch
EnglishDriving -> Starting the engine for your BMW 6 Series 2011-2017
Controls
Driving
The radio-ready state remains active if, e.g.,
the ignition is automatically switched off for the
following reasons:
Steptronic transmission
Starting the engine
▷
▷
▷
Opening or closing the driver's door.
Unfastening of the driver's safety belt.
1. Depress the brake pedal.
2. Press the Start/Stop button.
When automatically switching from low
beams to parking lights.
The ignition is activated automatically for a
certain time and is stopped as soon as the en‐
gine starts.
If the engine is switched off and the ignition is
switched on, the system automatically
switches to the radio-ready state if the lights
are turned off or, if correspondingly equipped,
the daytime running lights are activated.
Engine stop
Hints
Take the remote control with you
Starting the engine
Take the remote control with you when
leaving the vehicle so that children, e.g., can‐
not start the engine.◀
Hints
Enclosed areas
Apply parking brake and further secure
the vehicle if needed.
Do not let the engine run in enclosed
areas, since breathing in exhaust fumes may
lead to loss of consciousness and death. The
exhaust gases contain carbon monoxide, an
odorless and colorless but highly toxic gas.◀
Set the parking brake firmly when parking; oth‐
erwise, the vehicle could roll. On steep upward
and downward inclines, further secure the ve‐
hicle, e.g., by turning the steering wheel in the
direction of the curb.◀
Unattended vehicle
Do not leave the vehicle unattended with
the engine running; doing so poses a risk of
danger.
Before driving into a car wash
So that the vehicle can roll into a car wash ob‐
serve instructions for going into an automatic
car wash, refer to page 232.
Before leaving the vehicle with the engine run‐
ning, set the parking brake and place the trans‐
mission in selector lever position P or N to pre‐
vent the vehicle from moving.◀
Steptronic transmission
Switching off the engine
Repeated starting in quick succession
Avoid trying to start the vehicle repeat‐
edly and in quick succession. Otherwise, the
fuel is not burned or is inadequately burned,
posing a risk of overheating and damage to the
catalytic converter.◀
1. Engage selector lever position P with the
vehicle stopped.
2. Press the Start/Stop button.
The engine is switched off.
The radio-ready state is switched on.
3. Set the parking brake.
Do not wait for the engine to warm-up while
the vehicle remains stationary. Start driving at
moderate engine speeds.
70
